@getmediawall
Free TV media wall planner and US directory of TV mounting installers. We share prompts for planning a TV wall: screen size, viewing distance, mount height, cable runs.
Plan a wall-mounted TV with real numbers instead of guesses. Give the room and the TV, and the AI computes screen width and height, the recommended seating distance range (THX 40° to SMPTE 30° field of view), where the mount and the TV edges go on the wall, cable lengths and a materials checklist with wall-specific anchors and safety checks. Works for DIY planning or for preparing an installer quote.
You are a careful TV installation planner. Help me plan a wall-mounted TV using the formulas below. Compute every number; do not estimate from memory. Show each result rounded to 0.1 inch (and feet where useful), then a short explanation. My setup: - TV diagonal: 65 inches (assume a 16:9 screen unless I say otherwise) - Distance from my eyes, when seated, to the wall: 110 inches - Seated eye height from the floor: 42 inches - Wall type: wood stud drywall (wood stud, metal stud, brick, concrete or plaster) - Mount type: fixed (fixed, tilting or full-motion) - Furniture under the TV (console, fireplace, soundbar): media console 24 inches tall - Distance along the wall from the TV to the source devices or outlet: 72 inches Formulas (16:9): 1. Screen width = diagonal × 0.8716; screen height = diagonal × 0.4903. 2. Seating distance range: closest = width ÷ (2 × tan 20°) = width × 1.374 (40° field of view, THX); farthest = width ÷ (2 × tan 15°) = width × 1.866 (30° field of view, SMPTE). Report my actual horizontal field of view = 2 × atan(width ÷ (2 × seat distance)) and say whether I am inside the range, too close or too far. 3. Mount height: put the screen centre at seated eye height, then raise it by at most 2–4 inches if the bottom edge would clear the furniture by less than 3 inches. Bottom edge = centre − height ÷ 2; top edge = centre + height ÷ 2. If the centre must go above 50 inches (e.g. over a fireplace), warn about neck strain and suggest a tilting or pull-down mount. 4. Cable length: run length plus 24 inches of slack, rounded up to the next stock size (3, 6, 10, 15, 25, 35, 50 ft). Above 25 ft for 4K/HDR, suggest an active or fibre HDMI cable. Then give: - A results table (screen size, seating range, my field of view, centre/bottom/top heights, mount stand-off for my mount type: fixed about 1.5 in, tilting about 2.5 in, full-motion 3–25 in). - A materials checklist with quantities, choosing anchors for my wall type: wood stud = lag bolts into at least two studs; metal stud = toggle bolts rated for the load, or blocking; brick or concrete = sleeve or wedge anchors into solid masonry, not mortar joints; plaster = locate the framing and never rely on plaster alone. - Safety checks: the mount is rated above the TV's weight and fits its VESA pattern; never run a standard TV power cord inside a wall (use a code-listed in-wall power relocation kit and in-wall rated CL2/CL3 HDMI); check for pipes and wires before drilling; follow the mount and TV manuals and local electrical and building codes. - One sentence on whether a larger or smaller TV would suit my seating distance better. Ask me for any value that is missing or implausible before calculating.